Tweet When it comes to volume, a speaker’s rated wattage is only part of the equation There seems to be some confusion when it comes to how “loud” an amplifier can get. When it comes to “volume,” many musicians only consider the amplifier’s power or wattage rating, and in general, more watts does mean “louder. Decibels and levels Decibels abbreviated “dB” are a logarithmic unit of measurement that pertain to a ratio between two numbers.

Okay, I can see eyes rolling and glazing over, so I’ll simplify things, and attempt to keep the “math” to an absolute minimum. With a logarithmic scale, you can’t just add numbers in the usual way—a doubled number isn’t “twice as much,” but rather, many times more.

Using speaker wire, connect the shakers to a powered amp (most people go for a subwoofer amplifier). 3. Using an RCA split audio cable, connect the amp to the ‘subwoofer out’ jack on the receiver.

This will increase the capacity of the stereo speakers. Often the deck that suits your requirements and even the amplifier that delivers a good signal is produced by different firms. For people who desire strong sounds from their stereos from Kenwood and want to attach it to the Pioneer amplifier, few people know that the job is quite easy and can be done by people who may or may not have any experience with cars stereos. A wiring kit for the Amplifier Drill Removal tools for the trim panel Adapter for the wiring harness Steps Remove the ground cable from the vehicle.

It will be connected to the negative terminal of the battery. The ground cable joins the battery with the chassis of your vehicle. Use the mm wrench or head screwdriver Phillips to unscrew clamp of the cable. Take out the clamp and keep it away till you finish off with the installation of the amplifier.

Soon you will hook up the Kenwood car stereo with amp Join the terminal called the ring terminal with the positive cable of the battery.